Chevy & GMC Truck Intake Manifold Kit, Edelbrock, LS, 1947-1987
- A Very Affordable & Trouble Free Solution For Running A Late Model Motor
- Made In USA
- Solid State Electronics
- Dual Pattern Carburetor Flange (Square Or Spread Bore)
- Uses Factory GM Sensors & Coils (Not Included)
- Works With 24x Crank Sensors Only (Pre 2006 GM V8)
- Check Out The Additional Photos
So you have a carbureted small block truck and you keep seeing newer Chevys and GMC's making great great power with less cubic inches with the 1999 and up Vortec LS1 based truck motors. Here is your chance to use a late model (1999-2005) GM Vortec motor in your classic truck. This kit, developed by MSD & Edelbrock will let you use any Vortec 4.8, 5.3, 6.0, or the 5.7 LS1 or LS6 (1997-2004). The smaller 4.8 & 5.3 are plentiful and very affordable in salvage yards due to the complexity of the computer and wiring. All you need with this kit is a carburetor, and the factory sensors and coil packs from the donor vehicle. The Edelbrock/MSD ignition controller plugs into the factory sensors and coil packs and handles all computer tasks, while the carburetor does the fuel. The controller comes with 6 pre-set spark curves which will let you run whatever octane fuel you desire. Brackets are included to mount GM fuel, TH350 & 700R4 Detent/Kickdown Cables. See the additional photos for an example installed in an early Camaro.
Check item description for fitment.